The Water Weedsickle - HD has been redesigned for 2016. There are two new motors available in 12 volt and 24 volt versions, both offering increased power and performance. The Cutting System has been completely redesigned and is available in 4' and 6' (24 volt only) widths. You also have a choice of two shaft lengths to suit various cutting depth requirements.

Continuous duty rated 12 volt gearmotor, fuse protected
60" shaft
4' wide cutter bar

Continuous duty rated 12 volt gearmotor, fuse protected
76" shaft
4' wide cutter bar

Continuous duty rated 24 volt gearmotor, fuse protected
60" shaft
6' wide cutter bar

Continuous duty rated 24 volt gearmotor, fuse protected
76" shaft
6' wide cutter bar
- MOUNTS ON THE TRANSOM, SIDE OR BOW OF A BOAT.
- INFINITE TILT ADJUST ALLOWS THE MACHINE TO CUT ON AN ANGLE IN SHALLOW WATER OR TILT COMPLETELY OUT THE WATER FOR TRANSIT.
- TWO UNITS MAY USED, ONE ON EACH SIDE OF THE BOAT, TO DOUBLE THE CUTTING CAPACITY.
- ADJUSTS 360° TO CUT FORWARDS, BACKWARDS OR SIDEWAYS.
- SELF-SHARPENING CUTTING KNIVES.
- POWER BY A 12 VOLT DEEP CYCLE MARINE BATTERY (NOT INCLUDED). TWO 12 VOLT BATTERIES ARE REQUIRED FOR 24 VOLT MACHINES.
- TYPICAL CUTTING TIME FOR A FULLY CHARGED BATTERY IS 6 - 8 HOURS.
- CONSTRUCTED ENTIRELY OF ALUMINUM, STAINLESS STEEL AND HARDENED SPRING STEEL FOR YEARS OF TROUBLE FREE OPERATION.
- WEIGHS FROM 50 TO 59 LBS.

- The new standard 12 volt motor runs nearly 30% RPM faster and provides 15% more torque compared to the old Model-HD motor.
- An available 24 volt motor operates at the same speed as the 12 volt motor, however it provides 65% more torque for superior performance in tough conditions.
The 24 volts motor requires the use of two independent 12 volt batteries connected together as shown in the diagram below. A Connector Wire is provided with each machine. It is important not to connect a second battery to the boat's main battery as an improper connection could send a 24 volt current through the boat's electrical system causing serious damage.

- A new Knife Back System constructed of tough HSLA steel replaces the old agricultural steel guards creating a significant weight reduction without compromising performance or durability.
- Reverse facing serrations on the new Knife Backs help hold weeds in place to assist the cutting action.
- The 24 Volt machines come standard with a new 6' wide Cutter Bar. The cutting capacity of these machines rivals that of commercial harvesting boats costing many times that of the Water Weedsickle.
- New 'Twin Tip' Knife Sections provide 48 cutting edges versus 32 cutting edges on the standard 4' Cutting Bar. There are a staggering 72 cutting edges on the new 6' Cutter Bar.
- INFINITE TILT ADJUSTMENT
- CAST ALUMINUM CONSTRUCTION
- RATCHET TYPE HANDLES ALLOW EASY ADJUSTMENT IN TIGHT SPACES